[OAUGNet]-Re: Complete Job and Assign Serial Nos thu API/Interface

[Eric <ericthered732@yahoo.com>]

Hi, Vijay.

We are still on EBS 11i (11.5.10.2).  I am not sure about the complete job/assign serial number API in 11.5.10.2 for WIP jobs.  But I know that there's an API for Work Order-less Completions in 11.5.10.2 and R12 that essentially does the same thing.

Note: Work Order-less Completions are job-less transactions in WIP, but they auto-create a WIP job, or schedule number, in the WIP tables just like a discrete WIP job.

So keep researching.  Hopefully, someone else will reply to you with the specific API(s).

I've blind-copied my former API developer in case she knows the API off-hand.

Best regards,

Eric


-------------------
Date: Sat, 30 Aug 2008 14:58:01 +0100
From: "Vijay Srinivasan" <vijay.ebs@googlemail.com>
Subject: Complete Job &Assign Serial Nos thu API/Interface

Hi,

We have a requirement where we need to interface from external system,
the job completion transaction and associate serial numbers during
completion. Serial control of item is set at 'At Receipt'. When I try
to pass a transaction in WIP_MOVE_TXN_INTERFACE with transaction_type
as 2 (move and completion) and populate the serial number in
WIP_SERIAL_MOVE_INTERFACE (linked by transaction_id), I get the error
message -

"Assembly is under serial number control, no completion transactions
allowed from the Move Interface table".

Are serial completions not supported through API  in R12 or is this a bug?
Am I using the wrong interface/API?
Has anybody faced this requirement before?
Any suggestions on workarounds/possible solutions?

Thanks in advance!

(below are theentries in the two interface tables after they were
errored with the error message - "Assembly is under serial number
control, no completion transactions allowed from the Move Interface
table"

Regards,
Vijay




      

#############################################################
This message is sent to you because you are subscribed to the mailing list <OAUGNet@oaug.com>.
To unsubscribe, E-mail to: <OAUGNet-off@oaug.com>
To switch to the FEED mode, send any message to <OAUGNet-feed@oaug.com>
To switch to the DIGEST mode, E-mail to <OAUGNet-digest@oaug.com>
To switch to the INDEX mode, E-mail to <OAUGNet-index@oaug.com>
Send administrative queries to  <OAUGNet-request@oaug.com>